EXBOND 4000I

It has been formulated for the application to protect structure model of photo device. It can cure fast at low temperature.

+86-021-52272688

Product introduction

Product description

It has been formulated for the application to protect structure model of photo device. It can cure fast at low temperature.。

Features

Single component;
Low moisture absorption rate, high Tg;
Good adhesion on plastic materials.

Technical parameters

  • Typical Uncured Properties
  • Appearance
  • Viscosity @25°C
  • Thixotropic Index
  • Work Life@25°C
  • Storage Life@-40°C
  • EXBOND 4000I
  • Black paste with single component
  • 2W+CP
  • >2
  • >24hours
  • 1year
  • Test Description
  •  
  • Brookfield CP51@5rpm, 25℃
  • Viscosity@0.5rpm/Viscosity@5rpm
  • 25% increase in viscosity @ 25℃
  • Storage Life@-40°C
  • Cure process Data
  • Recommend Cure condition
  • EXBOND 4000I
  • 30 min@100℃,detail please refer to Cure Temperature-Time Profile
  • Test Description
  •  
  • Physiochemical Properties-Post Cure
  • Glass Transition Temperature(Tg)
  • Coefficient of Thermal Expansion
  • Die Shear Strength 25ºC
  • EXBOND 4000I
  • 100℃
  • Tg Below Tg  29 ppm/℃
    Tg Above Tg  101 ppm/℃
  • 25℃  10 kgf/die
  • Test Description
  • TMA penetration mode
  • TMA expansion mode
  • 2mm×2mm Silicon Die,Ag/Cu Leadframe,25℃

The data above indicate typical values only and are not intended to be used as specification limits.

Bonotec products are packaged in syringes or jars per customer specification. Available package sizes range from 1cc to 30cc and 1 ounce to 1 pound. For details, refer to the Bonotec Standard Package Data Set or consult your Customer Service Representative.

红韵彩票注册开户投注平台 天天红彩票下载 搜狐彩票注册开户投注平台 时时彩票注册开户投注 秒速赛车是真的吗 喜盈盈彩票注册 乐万家彩票注册开户投注平台 现金彩票注册开户投注平台 内蒙古11选5走势图 五百万彩票注册开户投注平台